15x15mm Teenycube Flytower Compatible Flysky Receiver F3 6A BLHeli_S ESC for Revenger55 RC Drone - 39.00 €

15x15mm Teenycube Flytower Compatible Flysky Receiver F3 6A BLHeli_S ESC for Revenger55 RC Drone


Specification:
Mount hole:15mm*15mm
Size: 20mm*20mm*23mm
Weight: 10g

Compatible Flysky 8CH AFHDS2A receiver:
Channels: IBUS 10CH / PPM 8CH
Model type: Multi-rotor
Frequency range: 2.408-2.475GHz
2.4GHz system: AFHDS 2A
Work Mode: PPM or IBUS
Failsafe available (IBUS)
Transfer method: FHSS
Antenna length: 50mm
No ground interference (Transmitting and receiving 1 m from the ground): >200m
Working current: 40mA
Size: 20*20*5mm
Weight: 1.1g
Compatible Transmitter: Compatible with FS-i4, FS-i6, FS-i6S, FS-i6X, FS-i10, FS-GT2E, FS-GT2G, FS-GT2F

Teenycube F3 6DOF Flight Controller:
STM32 F303 MCU
Firmware version: Betaflight 3.1
Firmware target: Omnibus
ESC Dshot protocol compatible(Need not modify)
SBUS/PPM/DSM2/DSMX input (Pin headers)
4PWM output (Pin headers)
Super Tiny Only 20x20mm, mount holes 15x15mm M2 screw
SPI Sensor MPU6000
2-4S Lipo Direct power
5V@1A BEC
3.3V output for spectrum Satellite Receiver
Built-in PDB
LED Strip solder pad ready
Buzzer solder pad ready
Weight: only 1.6g
Best for 60mm-80mm brushless frame

Teenycube 6A BLHeli_S Dshot 2 In 1 ESC:
Model:BS06D 2in1
Con. Current: 6A
Peak Current(10s): 10A
Input Voltage: 2S Lipo
BEC: No
Programming : YES
Cleanflihg/Betaflight pass-through ready
Firmware: Blheli_S 16.5
Net Weight: only 1.7g (Not include wire)
Size: 20*20mm
Mount hole: 15mm*15mm M2

Features:
-STM32 F303MCU+BLHELI_S ESC make your Operating feel more stabilly and silky
-Jaw-dropping flight performance
-LED_STRIP solder pin
-BUZZER solder pin
-Betaflight support
-Acro mode / Air mode /Angle mode support

Package included:
1 x Compatible Flysky 8CH AFHDS2A Receiver
1 x Teenycube F3 6DOF Flight Controller
2 x Teenycube 6A BLHeli_S Dshot 2 In 1 ESC