32bit Racing Flight Controller I-shaped Supports Spektrum Futaba FrSky Receivers PWM PPM
Description:
Item name: 32bit Racing Flight Controller
MCU: STM32F303CCT6
IMO: MPU6050
Weight: 4.6g
Mounting Holes: 3x3cm pattern with 3.2mm holes (compatible with most frame types)
Voltage: 2-6S (direct, max. 5s recommended)
Supported Receivers:
Installation & Setup:
Note: the USB port might get warm during operation. This is due to the used voltage regulator which needs to be able to handle 6s. This behavior should not a problem at all.
Just plug in the FC via Micro USB connection to your PC. Drivers should be installed automatically on WIN7-10. After the installation is complete, unplug the FC from the USB, plug it in again and hold the FC firm and level for at least 5 seconds!
Arming can be done via switch on the Transmitter or via stick input: Throttle down, Yaw right will arm, Throttle down, Yaw left will disarm.
The green LED will be lit constantly while the blue LED will blink, indicating the Gyro calibration. It will be solid afterwards and go off when the calibration is completed und the FC is ready to go.
Then start the Chrome GUI and select the COM port for the connection. If no port is shown, the driver installation might have failed.
Important! For safety reasons the PIDs will only be saved when NO LIPO is attached!
Package included:
1 x 32bit Racing Flight Controller
![DJI Neo - 10 Reasons Buy or [ Not Buy ]. - UCwojJxGQ0SNeVV09mKlnonA](https://i4.ytimg.com/vi/lG4mCfL_Rlw/hqdefault.jpg)
