Brand: Eachine
Item Name: ETX Hit & Miss Vertical STEM Engine Upgraded Model
Product Size: 180*125*220MM
Cylinder Diameter: 22MM.
Displacement: 6 CC
Ltinerary: 20MM.
Weight: 1610G
Total Weight of Packaging: 2200G
Ignition Power Supply: 3.7V, 3pcs AA Batteries(Not Included)
This is a vertical engine, we have upgraded, added a mechanical water pump, cooling water tank, it can carry out water cooling cycle.
There are exhaust pipes.Engine parameters.
Engine Startup Steps:
1.Open the bottom plate to check the wiring of the engine, connect the fuel tank pipe, and install the three No. 5 batteries to close the bottom plate.
2.Fill the fuel tank with gasoline (95#). When the filling is completed, make sure there is no air in the oil pipe.
3.On the right side of the engine, slowly turn clockwise to buy more than one turn, its role can make the mixed gasoline fully enter the cylinder.
4.Turn on the power switch and turn the flywheel clockwise to start the engine clockwise on the right side of the engine.
Precautions:
1.If the ignition device is normal and the cylinder is under normal compression, if the machine still does not start normally, it is very likely that the carburetor needle should be adjusted.
2.screw the screw on the top of the carburetor, then loosen 1/4 turn, start the flywheel, This can be done several times to make the mixing ratio of gasoline and air reach the normal working mix ratio.
3.Check if the water tank lacks water. If there is air in thecooling pipe, the pump can't work normally. Need to loosen the water pump outlet screw. Turn the engine to exhaust. When it is normal, the water is pumped out. Screw the screw.
4.When the machine stops, the power switch should be turned
5.Due to the different display and different light, the picture may not reflect the actual color of the item. Thanks for your understanding.
6.Please allow little differs due to manual measurement.
7.Kids should be accompanied by adult.
Package Included:
1 x Eachine ETX Hit & Miss Vertical STEM Engine Upgraded Model
