GEPRC GEP-VTX58200-M 5.8G 48CH 0/25/100/200mW FPV Transmitter 20x20mm Hole for RC Drone FPV Racing
Note: Please install antenna (must be done) before debugging or testing VTX(and OSD), or lead to VTX not working properly.
Specification:
Brand name: GEPRC
Item name: GEP-VTX58200-M FPV Transmitter
Channel output : 48Ch(A,B,E,F,H,R)
Input voltage : 7-24V DC (2-6S)
Vtx output the camera voltage: 5v
Power transmission: 0mW / 25mW / 100mW / 200mW
Size (mm): 25 * 25 * 4.5
Mounting Holes Dimension:20*20mm
Connector type: IPEX Connector
Weight: 3.5g(including antenna)
Feature:
Support Power tuning;
Transmit power 4 gear switch: 0mw/25mW/100mW/200mW;
The output power is stable ,the far transmission distance: ≥0.6km@25mW, ≥1km@100mW, ≥ 1.5km@200mW
Output 48 frequency points, and has R group 8 race frequency at the same time using each other without interference;
Frequency lock fast, boot does not interfere with companions;
Full format video format: NTSC /PAL;
Wide input voltage range. low power consumption; 7V~24V, +12V/170mA@200mW;
Small volume: 25mm×25mm×4.5mm;mounting holes 20mm×20mm(4 * M2) correspond exactly mini CC3D NAZE32 F3 F4 Flying control
Light weight: ≤3.5g(including antenna)
How to use:
1. Set the Channel
In standby mode, press and hold the key for 3 seconds, the blue LED flashes, short press, change the channel value.Every time 1 press will change the CH, followed by 1CH to 8CH cycles.
2. Set the Band
In the channel setting mode, press and hold the key for 3 seconds, the green LED flashes, briefly presses, changes the frequency group value.Every time 1 press will change the band, and then the A band to F band loop.
3. Set the Power
In the band setting mode, press and hold the key for 3 seconds, the red LED flashes, short press, change the output power value.Every time 1 press will change the power, followed by 25mW / 100mW / 200mW cycle.
Packae Included:
1 x GEP-VTX58200-M FPV Transmitter
