Kakute F4 V2 Flight Controller with Atlalt HV Stack

Main Features:
● Support Betaflight and Cleanflight.
● Soft-mounting built in. The IMU chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
● New high-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up to 32KHz.
● Copper PCB allows up to 120A maximum continuous current.
● Dedicated bootloader button for easy firmware flashing.
● Low-profile design fits into even very compact frames.
● Input voltage: 7 - 42V. Power the board directly from the flight pack, up to 6s.
● Automatic voltage monitoring. No need to run a separate VBat wire for voltage monitoring; the Kakute F4 monitors voltage directly from the battery power lead.
● Filtered voltage output for clean, noise-free video. On-board regulators output 5V at up to 1.5 amps and 3.3V at up to 200mA to power peripherals such as receiver, video transmitter, FPV camera, or LED strip.
● Support BLHeLi pass-through for easy ESC upgrade and configuration.

Specifications:
MCU: STM32F405RGT6 32-bit processor
IMU: ICM20689 ( SPI )
USB VCP driver ( all UARTs usable simultaneously; USB does not take up a UART )
Support serial receivers ( SBUS, iBus, Spektrum, Crossfire ) only. PPM and PWM receivers are not supported
128 Mbit dataflash chip for Blackbox logging
Mounting holes: standard 30.5mm square to center of holes

Product Safety Disclaimer:
We do not accept any responsibility or liability for misuse of this or any other product. All our products are extensively tested to comply with rigorous and strict QC standards. For certain products (e.g. toys, knives, etc.), we recommend proper supervision as we cannot be held liable for misuse or accidents.

Small Parts Disclaimer:
These toys contain small parts, not for children under 3 years in case of swallowing or choking . We do not accept any responsibility or liability for misuse of this or any other product.