MATEKSYS F722-HD F7 Flight Controller 3~8S STM32F722 MPU6000 32M Flash Blackbox 5V/8V BEC comptiable DJI FPV Air Unit
Specification:
Brand name: MATEKSYS
Item name: F722-HD Flight Controller
FC
- MCU: 216MHz STM32F722RET6
- IMU: MPU6000 (SPI)
- Baro: BMP280 (I2C)
- Blackbox: 32M-byte Flash memory (SPI)
- OSD: Support external DJI OSD/FrskyOSD, No Analog MAX7456 OSD built-in
- 6x Uarts with built-in inversion
- 1x Softserial_Tx option
- 10x Dshot/PWM outputs
- 1x I2C
- 4x ADC (VBAT, Current, RSSI, AirSpeed)
- 2x SH1.0_8pin connector (Vbat/G/Curr/Rx3/S1~S10)
- 1x SH1.0_6pin connector for DJI FPV Air Unit
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- Switchable 8V output
- PWM camera control: Yes
- TR/SA VTX control: Yes
- WS2812 Led Strip : Yes
- Beeper : Yes
- RSSI: Yes
- Analog Airspeed sensor: Yes
- Digital Airspeed sensor: Yes
Power
- Input: 9~36V (3~8S LiPo)
- BEC: 5V 2A cont. (Max.3A)
- BEC: 8V 2A cont. (Max.3A)
- LDO 3.3V: Max.200mA
- Battery Voltage Sensor: 1:10 (Scale 110)
- No Current Sensor built-in
FC Firmware
- BetaFlight unified target: MATEKF722HD(MTKS)
- INAV target: MATEKF722PX
Physical
- Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
- Dimensions: 36 x 36 x 5 mm
- Weight: 6.5g
Package Included
- 1x FC F722-HD
- 6x Silicon grommets M4 to M3
- 1x SH1.0_8pin cable 5cm
- 2x SH1.0_8pin connectors
- 1x SH1.0_6pin to GH1.25_8pin cable 8cm
Tips:
- BetaFlight unified target MATEKF722HD , or download betaflight firmware from HERE
- Select âMATEKF722HDâ in pull-down list of BetaFlight configurator when you flashing it.
- In BetaFlight CLI mode, type â resource SERIAL_TX 11 A02 â if you want to use TX2 pad as softserial1_TX.
- If using FrskyOSD module, enable FrskyOSD on Uart6 in BF configurator 10.7 or latest.
***
- INAV target MATEKF722PX
- INAV firmware has FrskyOSD enabled on Uart6 by default, replace it with âDJI FPV VTXâ protocol.