83.99 for 21g Eachine AE65 7 Anniversary Limited Edition 65mm 1S Tiny Whoop FPV Racing Drone BNF CADDX ANT Lite Cam 5A ESC NX0802 22000KV Motor - discount coupon

Flight controller

(Frsky SPI RX version) CRAZYBEEX FR V1.0 FC Firmware target: CrazybeeF4FR

(Flysky SPI RX version) CRAZYBEEX FS V1.0 FC Firmware target: CrazybeeF4FS

(External Frsky RXSR version) CRAZYBEEX PNP V1.0 Firmware target:CrazybeeF4DX

(External TBS CRSF NANO version) CRAZYBEEX PNP V1.0 Firmware target:CrazybeeF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky/Flysky receiver or no receiver
Built-in 5V 1A BEC
Built-in voltage detection

Motor

Mode: NX0802 22000KV
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
Weight(g): 1.7g
No.of Cells(Lipo): 1S only

Onboard 4in1 ESC

MCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HV

Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Default protocol: DSHOT600

Propellers

Gemfan 1219-3

Center Thickness:5mm

Prop Disk Diameter:31mm

Center Hole Inner diameter:1.0mm

Onboard 5.8g VTX

Output power: 25mw
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Race band

Smartaudio ready

Caddx ANT Lite Camera

Image Sensor 1/3" CMOS Sensor

Horizontal Resolution 1200 TVL

TV System NTSC/PAL switchable

MENU SUPPORT

IMAGE 16:9

Synchronization Internal

Electronic Shutter PAL: 1/50~100,000; NTSC: 1/60~100,000

S/N Ratio >52dB (AGC OFF)

Video Output CVBS

Lens 2.1mm

Min. Illumination [email protected]

Auto Gain Control YES

BLC YES

WDR Global WDR

DNR 2 DNR

Dimensions 14mm*14mm

Wide Power Input DC 3.7-18V

Work Temperature -20℃~+60℃

Work Humidity 20%~80%

Weight 1.5g (N.W.)

Lipo Battery

Capacity:250mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Size: 55mmx12mmx7mm
Weight: 6.5g

Connector: ET2.0

Multi port Lipo/Lihv battery charger

Weight: 41g
Dimensions: 82x51x22mm
Input: DC 7V-22V
Output switchable: Fixed at 200~600 milliamps
Cutoff voltage switchable:
4.20v cell charging cutoff (+- 0.5% margin of error) for 1S Lipo Battery
4.35v cell charging cutoff (+- 0.5% margin of error) for 1S 3.8V LIHV Battery

Onboard Frsky SPI D8 Receiver Version

SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 model

Channels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m

SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
Failsafe support

External Frsky R-XSR receiver version

Number of channels: 16CH (1-16CH from SBUS channel, 1~8CH from CPPM channel)

Operating Voltage Range: 3.5V~10V

Operating Current:70mA@5V

Firmware Upgradable

Compatibility: FrSky X Series modules and radios in D16 mode

Could support Frsky New ACCESS Protocol ( Upgrade firmware)

Weight: 1.5g

Original TBS CROSSFIRE Receiver ,CRSF Protocol , Official TBS transmitter compatible