FuriBee Stormer 220mm FPV Racing Drone - BNF

Brief Introduction:
Featuring the brand new X-type carbon fiber frame, FuriBee Stormer 220 flies with higher maneuverability and looks more modern. CNC reinforced body, aerodynamic propellers and tightly fixed components allow 220 deliver breathtaking high-speed FPV racing. Easy, fun and safe to fly! Plus, it can be powered by 3 - 6S Lipo battery.

Specifications:
- Material: 3K carbon fiber frame
- Arm thickness: 4mm
- Wheelbase: 220mm
- Frame weight: 95g

Omnibus F4 PLUS Flight Controller:
- MCU: STM32F405RGT6
- Motion processing unit: MPU6000
- Integrated OSD chip: AT7456E
- Video transmitter: 5.8G 48CH 25MW / 100MW / 200MW
- Image transmission: IPEX-2 antenna connector
- Receiver port: DSMX, IBUS, PPM, SBUS
- LED_Strip port: yes
- LED buzzer module: yes
- Voide INPUT port: switchable from 5V to battery voltage; default input: 5V
- Supported micro SD card: included
- UART3 ports: TX3, RX3
- LC filter
- Built-in 5V 3A BEC

 Electric Speed Controller:
- 4 IN 1 BLHELI-S 35A 3-6S
- Communication protocol: Dshot, Oneshot, Multishot, PWM
- Firmware: BLHELI_S J_H_15_REV16_6

Brushless motor:
- Mode: FuriBee 2308
- KV: 2200KV
- Input voltage: 3-6S
- Maximum pulling force: 1865g

Camera:
- FuriBee HS1177 2.5mm 600TVL
- Lens: 2.5mm
- Wide camera: 130 degrees
- Sensor: CCD 1/3 inches Sony SUPER HAD II CCD
- Resolution:650 tvl ( b / w ), 600tvl ( color )
- Minimum illumination: 0.01Lux
- Operating voltage: 5V-22V
- Operating current: 70mA
- Dimension: 25 x 25mm
- OSD menu: support
- Pixel: PAL: 976 ( H ) x 494 ( V ); NTSC: 768 ( H ) X 494 ( V )
- DNR: 2DNR
- WDR: D-WDR
- Power: DC5V - 22V
- Workplace temperature: -10 degrees to 50 degrees
- Working humidity: 20 to 80 percent

Antenna:
- Frequency: 5.8G
- Impedance: 50 ohm
- Gain: 5dBi
- Maximum power: 50W
- Connector: RP-SMA male
- VSWR: less than 1.5:1
- Polarization: RHCP
- Radiation: omnidirectional

Propeller:
- 5042 three-blade

LED Buzzer Module
- Operating voltage: 5V

Receiver
- PNP: no
- BNF: Frsky XM Plus Receiver
- 1.5km long-distance reception with dual antennas
- 16 channels available. Compatible with D16 mode transmitters
- Operating voltage: 3.7 - 10V
- Operating current: 30mA at 5V

Product Safety Disclaimer:
We do not accept any responsibility or liability for misuse of this or any other product. All our products are extensively tested to comply with rigorous and strict QC standards. For certain products (e.g. toys, knives, etc.), we recommend proper supervision as we cannot be held liable for misuse or accidents.

Small Parts Disclaimer:
These toys contain small parts, not for children under 3 years in case of swallowing or choking . We do not accept any responsibility or liability for misuse of this or any other product.