Specification:
Matek F405-STD (user manual):
Brand: Matek Systems
Item name: Flight Control Board
Size: 36x36mm
Mounting hole: 30.5mm
Weight: 7g
MCU: 168MHz STM32F405RGT6
IMU: 32K ICM20602 gyro/accelerometer (SPI)
Baro: BMP280 (I2C)
OSD: BetaFlight OSD w/ AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
VCP, UART1, UART2, UART3, UART4, UART5
Built in inverter for SBUS input (UART2-RX)
PPM/UART Shared: UART2-RX
SoftSerial on TX2, S5 or S6 optional
Camera control on S6 or DAC optional
Smartaudio & Tramp VTX protocol supported
Battery Voltage Sensor: 1:10
Current Sensor: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option)
BEC 5V: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option)
LDO 3.3V: Max.300mA
I2C1 SDA & SCL: Yes
WS2812 Led Strip : Yes
Beeper : Yes
RSSI: Yes
Matek FCHUB-6S (user manual):
Brand Name: Matek
Model: FCHUB-6S
Item Name: Power Distribution Board Built-in Current Sensor
Size: 36x36mm
30.5x30.5mm Hole Mounting , M3
Weight: 8.5g
BEC Output: 5V & 10V
5V BEC Output:
- Designed for RC Receivers, Flight Controllers, OSD and Servos.
- DC/DC synchrous buck regulator
- Voltage: 5.0V (4.9-5.1)DC
- Current: 1.5A (Max. 2.0A 10S/minute)
- Short-circuit tolerant ( 2 Seconds/minuate)
10V BEC Output:
-Designed for VTX or FPV Camera
- Voltage: 10.0V (9.8-10.2) DC
- Current: 1.5A ( Max. 2.0A 10S/minute)
- Short-circuit tolerant ( 2 Seconds/minuate)
- 10V can be used to power cameras labeled as 12V.
- The 3S Lipo input voltage should be 11V plus.
Current Sensor Module
- Max. Range: 184A
- 3.3V ADC
- Scale the output voltage to milliamps ( 1/10th mW/A): 179
Package included:
1x flight control board
2x 0.5mm*16Pin 5cm Flexible Flat Cable
4x M3 Anti-vibration Standoffs
1x FCHUB-6S PDB Board
1x bag of screws
![DJI Neo - 10 Reasons Buy or [ Not Buy ]. - UCwojJxGQ0SNeVV09mKlnonA](https://i4.ytimg.com/vi/lG4mCfL_Rlw/hqdefault.jpg)
