Micro 48CH 5.8G 25MW/100mW/200mW/400mW/600MW Switchable FPV RC Drone Transmitter Module with OSD SBUS Control

Transmitted by 5.8G ISM frequency band analog transmission. It has the characteristics of stable output power, long transmission distance and strong power filter. It can ensure that the image has no snowflakes and no striations under the maximum throttle. The M3 screw holes of 30.5 x 30.5MM are designed by stacking and installation. The same fixed hole is used for the transmission of the mainstream flight control, which perfectly fits the upper part of the flight control, improves the space utilization and safety of the rack, and can assemble the tower structure arbitrarily. The image transmission is the first to use the flight control OSD (TXD) signal to control the transmitting frequency point of the chart remotely, and only needs any TXD (serial port transmission) to connect to the RXD transmitted by the serial port. Support PIT mode tuning.
Characteristic:
1, The output power is stable and the transmission distance is far away.
2, Fast 5 gear power switching, independent two red lights, indicating the current launch power of 25/200/400/600MW.
3, The frequency point uses 4X3 LED to display 48 channel values.
4, Support OSD remote tuning, support PIT mode tuning (0MW power output, only in OSD).
5. The board - borne power filter is used to isolate the interference from the power motor, and the flight picture is still clear.
6, Small volume, large free, the antenna uses MMCX to SMA (with 100MM extension line), reducing the occupancy of the PCB board.
7, Powerful power chip, input up to 27V, output 5V/1A low ripple, small interference.
8, Do not install the antenna electricity, will not burn out the transmission.
9, Small size: 36mmX36mm, the installation hole 30.5mm x 30.5mm completely corresponding to the CC3D NAZE32 F3 F4 F7 and other mainstream flight control.
10, Light weight: less than 6.4g (not including antenna and plug line)
Performance indicators:
1. Input voltage: DC 7V-27V
2. Input current: 600MW = 360 MA + 10MA at 16.4V (4S)
3. Output voltage: DC 5V 1A
4, power switch: five 25MW, 100MW, 200MW, 400MW, 600MW
5, signal channel: 48
6, frequency point switching: manual key / OSD (simultaneous support)
7, antenna interface: MMCX (distribution to SMA extension line)
8, shape size: 36MM X 36MM X 9MM
9,hole distance: 30.5 X 30.5MM, M3

Small Parts Disclaimer:
These toys contain small parts, not for children under 3 years in case of swallowing or choking . We do not accept any responsibility or liability for misuse of this or any other product.