Sub250g FPV Drone Build - 04 - DJI O4 Lite Install and Setup

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST:
SUPPORT ME ON PATREON at:
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: /
---
I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.
Buy the Analog Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
Buy the HD-Ready Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
---
All videos in this series are in this playlist:
---
00:00:00 - This is part of a series
00:01:06 - Install the O4 on the FC stack
00:04:26 - Acthivate DJI and update firmware
Download DJI Assistant Consumer Drones Edition at:
00:05:44 - Bind the vTX to the goggles
00:06:35 - Ham Unlock
Download the ham unlock file at:
00:08:33 - Install Betaflight Configurator
Download and install Betaflight Configurator:
00:10:13 - FAILED TO OPEN SERIAL PORT
00:10:51 - Configure FC for On-Screen-Display (OSD)
set osd_canvas_width = 53
set osd_canvas_height = 20
save
00:15:29 - Lay out OSD elements
My Betaflight OSD Preset is:
00:17:16 - Install the camera plates
00:18:46 - Install the O4 camera
00:21:49 - Mount the O4 antenna (not yet though)
00:23:25 - Recap