Techninės specifikacijos
Basic Information
Weight
12.5g
Price
86.77 €
Integrated Circuits
Main MPU
MPU6000
Barometer
BMP280 (I2C) Warning:Do not apply conformal coating on the berometer because the air hole can be clogged.
Specifications
Firmware
BLHeli32 SpeedyBee 4in1
Blackbox
16MB onboard dataflash
Dimension
41 * 45 * 6.5mm
WiFi
Support, used for data transfer, e.g firmwareflashing, and Blackbox analysis.
Power Input
3-6S Note: Strongly recommended to solder the filtering capacitor between VBAT"+" and" -"
Mounting
30.5 x 30.5mm, 4mm hole size
MCU
STM32F722
BetaFlight Camera Control Pad
Yes
ESC Signal
M1 - M4
UART
Full UART * 5(UART1, UART2, UART3, UART5, UART6)
ESC Telemetry
Support
I2C
Used for external Magnetometer, Sonar, etc.
Buzzer
BZ+ and BZ- pad used for 5V Buzzer
BOOT Button
Used to easy enter DFU mode
RSSI Input
RSSI input solder pad
Continuous Current
45A * 4
Burst Current
55A(10S)
ESC Protocol
DSHOT300/600/1200
Power Output
VBAT
Current Sensor
Support (Scale 168)
SmartPort
Use any TX pad of UART for the SmartPort feature.
ESC Telemetry UART
UART4 RX
USB
Type-C
OSD
BetaFlight OSD w/ AT7456E chip
BLE
Support, used for Flight Controller configuration
DJI Air Unit slot
A full DJI Air Unit JST slot onboard
5V BEC x 1
5V output x 7 , 6 pads, and a BZ+ pad used for Buzzer, the maximum load current in total is 2.5A.
9V BEC x 1
9V output x 2 , 1 pad and another one used for DJI slot, the maximum load current in total is 2.5A.
4.5V power output
1 * 4.5V output pad
3.3V power output
1 * 3.3V output pad, the maximum load current is 500mA.
LED pin
Used for WS2812 LED
Support Flight Controller Firmware
BetaFlight(Default), EMUFlight
Target name
SPEEDYBEEF7V2
BMP280(I2C) Warning
Do not apply conformal coating on the berometer because the air hole can be clogged.
1
10 (Scale 168)
Supported Motor
1900KV or below should be needed for 6S
3-6S Note
Strongly recommended to solder the filtering capacitor between VBAT"+" and" -"
