Techninės specifikacijos
Basic Information
Weight
10.7g
Price
36.28 €
Integrated Circuits
Barometer
BMP280
Specifications
Dimension
41(L) x 38(W) x 8.1(H)mm
Product Name
SpeedyBee F7 V3 Flight Controller
Power Input
3S - 6S Lipo
Mounting
30.5 x 30.5mm( 4mm hole diameter)
MCU
STM32F722
IMU(Gyro)
BMI270
USB Port Type
Type-C
OSD Chip
AT7456E chip
BLE Bluetooth
Supported. Used for Flight Controller configuration,built-in a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip
DJI Air Unit Connection Way
Two ways supported: 6-pin connector or direct soldering.
BetaFlight Camera Control Pad
Yes(CC pad on the front side)
5V Output
10 groups of 5V output, three +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. The total current load is 2A.
9V Output
2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 4A.
3.3V Output
Supported. Designed for 3.3V-input receivers. Up to 500mA current load.
4.5V Output
Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 500mA current load.
UART
5 sets(UART1, UART2, UART3, UART4(For ESC Telemetry), UART6)
I2C
Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc.
Buzzer
BZ+ and BZ- pad used for 5V Buzzer
BOOT Button
Supported. [A]. Press and hold BOOT button and power the FC on at the same time will force the FC to enter DFU mode, this is for firmware flashing when the FC gets bricked. [B]. When the FC is powered on and in standby mode, the BOOT button can be us
RSSI Input
Supported. Named as RS on the front side.
Supported Flight Controller Firmware
BetaFlight(Default)
Firmware Target Name
SPEEDYBEEF7V3
SmartPort
Supported
Flash FC Firmware Wirelessly
Supported. Please enter MENU > FC Firmware Flasher
Download/Analyze Blackbox
Supported.Please enter MENU > Blackbox Analyzer
Flash(for BlackBox)
500MB
ESC Signal Pads
M1 - M4 on bottom side and M5-M8 on front side.
ESC Telemetry UART
R4(UART4)
LED Pad
Used for WS2812 LED controlled by Betaflight firmware.
6-pin DJI Air Unit Plug
Supported. Completely compatible with DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed.
Two ways supported
6-pin connector or direct soldering.
