3D-Hawk 80 Shockflyer
It's a great aeroplane -- with 3 minor changes you'll enjoy it even more:
(i) to prevent the rudder/elevator carbon pushrod from flexing I glued EPS-pieces as guides to the fuselage half way down the pushrod.
(ii) to prevent the rudder from landing-induced damages I glued a piece of EPP onto the tail of the fuselage.
(iii) to stiffen the wings I glued two additional cfk-rods (1mm x 3mm x L) into the wings.
3D-Hawk 80 Shockflyer
Wingspann: 800mm
Motor: ADH300L Brushless Outrunner 1100kv (39g)
Bec: Turnigy 18amp Speed Controller
Propeller: GWS 9050
Thrust: 570g at 11.1V (according to fabricator)
Battery: Zippy 3s-1000mAh 25C
Servos: 3x HXT 900
Rx: OrangeRx R410 Spektrum DSM2 Compatible 4Ch 2.4Ghz Receiver
Weight: 247g + 82g (Lipo 3s1p/1000mAh) = 329g
Supplier: HobbyKing
Super 3D flatform EPO R/C Plane w/ Brushless Motor
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=14522
Filmed by the pilot with the HD-KeyChainCam 808 #11 mounted on a headband..
Music: "Et maintenant" (Isabelle Boulay covering Gilbert Bécaud)