This is a Timelapse of my biggest print project so far on my own designed/built printer.
It's 500x170x700(mm) and weights 3 Kilograms of Filament.
▼ ▼ ▼▼ ▼▼ CHECK LINKS BELOW 4 PICS ▼ ▼ ▼ ▼ ▼ ▼
Hardware / Software:
Hotend: E3D6lite - https://e3d-online.com/
Extruder: BONDTECH QR - http://www.bondtech.se
Electronics: Arduino/Ramps 1.4
Stepperdriver: TMC2208 - http://www.watterott.com/
Slicer: Simplify3D - https://www.simplify3d.com/
Controlled: Raspberry Pi3 & Octoprint - https://www.raspberrypi.org/ / https://octoprint.org/
MORE PICS and Information about this print:
https://www.thingiverse.com/make:402264
CREDITS for the 3D-Model: (Andrew Askedall) aaskedall
https://www.thingiverse.com/thing:919475
