The 3D model is made by KP-ShadowSquirrel (http://kp-shadowsquirrel.deviantart.com/)
The music is made by PinkiePieSwear (http://youtu.be/cP0f5rvVkAU)
Most of the support removal process was out of the sight of the camera, it's difficult to work and watch what the camera is recording at the same time.
I had two issues with this print :
- I set the support structures too dense, it was much harder to remove them compared to my previous prints.
- See those horizontal stripes every millimeter ? That's Z wobble, it's caused by the Z axis treaded rods that are not perfectly straight, I need to remove and straighten them to solve that issue before the next print.
Size : 73mm high
Material : white PLA (bioplastic)
skeinforge settings :
Layer height : 0.1mm
With over thickness : 4
infill solidity : 0.2
Infill feedrate : 100mm/s
Perimeter feedrate : 20mm/s
Support feedrate : 200mm/s
Softwares used :
Model editing and conversion to stl : blender
Slicing : skeinforge
Motion control : EMC2
