Fun day at the chula vista remote control airport will be going back for more video.
A radio-controlled (model) aircraft (often called RC aircraft or RC plane) is a small flying machine that is controlled remotely by an operator on the ground using a hand-held radio transmitter. The transmitter communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on the position of joysticks on the transmitter. The control surfaces, in turn, affect the orientation of the plane.
Flying RC aircraft as a hobby has been growing worldwide with the advent of more efficient motors (both electric and miniature internal combustion or jet engines), lighter and more powerful batteries and less expensive radio systems. A wide variety of models and styles is available.
Scientific, government and military organizations are also utilizing RC aircraft for experiments, gathering weather readings, aerodynamic modeling and testing, and even using them as drones or spy planes.
Jets tend to be very expensive and commonly use a micro turbine or ducted fan to power them. Most airframes are constructed from fiber glass and carbon fiber. For electric powered flight which are usually powered by electric ducted fans, may be made of styrofoam. Inside the aircraft, wooden spars reinforce the body to make a rigid airframe . They also have kevlar fuel tanks for the Jet A fuel that they run on. Most micro turbines start with propane, burn for a few seconds before introducing the jet fuel by solenoid. These aircraft can often reach speeds in excess of 320 km/h (200 mph). They require incredibly quick reflexes and very expensive equipment, so are usually reserved for the expert.
In the U.S.A the FAA heavily regulates flying of such aircraft to only approved AMA Academy of Model Aeronautics sites, in where certified turbine pilots may fly. Also, the AMA requires model aviation enthusiasts who wish to operate miniature gas turbine powered RC model aircraft, to be certified in the operation of the type of gas turbine engine, and all aspects of safety in operating such a turbine-powered model aircraft, that they need to know in flying their model.[1]. Some military bases allow such high tech aircraft to fly within limited airspace such as Kaneohe Marine base in Hawaii, and Whidbey Island NAS in Washington State.
An average turbine aircraft will cost between $150--$10,000 with more than $20,000 all-up becoming more common. Many manufactures sell airframes such as Yellow Aircraft and Skymaster. Turbines are produced from The Netherlands (AMT)to Mexico (Artes Jets). The average microturbine will cost between $2500 and $5000 depending on engine output. Smaller turbines put out about 12 lbf (53 N) of thrust, while larger microturbines can put out as much as 45 lbf (200 N) of thrust. Radio control jets require an on board FADEC (Full Authority Digital Engine Control) controller, this controls the turbine, just like a larger turbine. RC Jets also require electrical power. Most have a lithium polymer (LiPo) battery pack at 8-12 volts that control the FADEC. There is also a LiPo for the onboard servos that control ailerons, elevator, rudder, flaps and landing gear.
Of much less complexity are the types of RC jet aircraft that actually use an electric motor-driven ducted fan instead to power the aircraft. So called "EDF" models can be of much smaller size, and only need the same electronic speed contoller and rechargeable battery technology as propeller-driven RC electric powered aircraft use.
South County's Premier Club For The Model Aircraft Enthusiast Chula Vista Model And Radio Control Club is located off the 5 Freeway and Dairy Mart Road in San Diego, California. Situated minutes away from the USA/Mexico border, our club is easy to get to from anywhere in San Diego County. CVMRCC features a 500' hard-surface runway with tables and chairs in our shade-covered pit area. Membership dues are among the lowest in the county, and the club enjoys a widespread reputation for friendliness and congeniality.
