Binding procedure ImmersionRC EzUHF
- Connect the EzUHF Tx to the R/C Transmitter, switch to low power mode, hold down the pushbutton, and turn on the radio.
- As soon as a periodic beeping starts, let go of the button.
- Apply power to the receiver, and within 10 seconds, hold down the binding button on the receiver. After - 1 second the LED should extinguish, and shortly after, it should flash 3 times, indicating binding success.
If instead, the LED flashes
6, or 10 times, quite quickly, then binding failed, and must be re-attempted.
- Power down the Tx, and Rx. Binding is complete.
Finally, make the Command Sticks Calibration on Naza M-V2 software.
TBS DISCOVERY PRO
http://www.optimum-system.ch/fr/home/8-tbs-discovery-pro-long-range-2g4-video-ezuhf-rc-rtf.html
Frame et Moteur :
1x TBS discovery Pro Gimbal
4x 900kV Moteur TBS
4x TBS variateur ESC 30A
4x Hélices Graupner E-PROP 9x5"
Contrôleur de vol :
1x DJI Naza M-V2 + GPS + LED
1x DJI IOSD mini
1x DJI Bluetooth LED
