This charger reads incorrect voltage on cell 1 on a 6 cell LiPo battery.
The actual voltage on cell 1 is about 4.1Volt, but the charger reads 4.3 Volt.
I enter the calibration menu to adjust the reading down from 4.3 Volt to 4.1 Volt.
However, the calibration range is only 0.25 Volt, so as I scroll down to adjust the reading, I can only go down to 4.18 Volt. It is not possible to adjust the voltage further down to 4.1 Volt.
This is a problem, because the chargers balance output will assume that cell 1 reach 4.2 Volt while it is actually lower than 4.2 Volt when fully charged. It is NOT possible to adjust the reading correctly.
