DIY Prop Balancer

Name: DIY Prop Balancer
Uploaded: 2018-03-08T00:40:21+02:00
Description: This one was made with 8mm perpex from the back of an old flat screen monitor. The hub runs on a tiny pip on one side and the other side has a gap of about 2mm

Prisijunkite, kad balsuotumėte

Aprašymas

This one was made with 8mm perpex from the back of an old flat screen monitor. The hub runs on a tiny pip on one side and the other side has a gap of about 2mm between the shaft and the maghnet so there's no friction whatsoever.