A quick (by my standards) look at a processing and software issue I found with the Autel MaxiSys MS908. Just a reminder to never trust data, always test, dont guess that your aftermarket tool is correct!
Weekly Training Available at www.Patreon.com/KeithPerkins
Check Out My Amazon Store HERE:
https://tinyurl.com/yc8d99vf
Some other tools I use:
Launch Diagun IV X431
https://amzn.to/2SVxG27
Autel Elite
https://amzn.to/2MfabON
SDT-206 Smoke Machine Kit
https://amzn.to/2FyLQm1
Redline Smoke Fluid
https://amzn.to/2MbfKhv
PicoScope 4 Channel Kit
https://amzn.to/2Mfcy49
Hantek CC-65 Low Amp Clamp
https://amzn.to/2T4w9Xm
Hantek CC-650 High Amp Clamp
https://amzn.to/2RVgGeW
AESWave Uscope
https://amzn.to/2Fw4Fqx
VVDI Key Tool
https://amzn.to/2SXa4Ky
FLIR ONE Thermal Imager
https://amzn.to/2MbcjHo
Streamlight ProTac 2L-X
https://amzn.to/2VVq0yH
EBL 18650 Batteries
https://amzn.to/2Mbi6gj
Immobilizer Coil LED Tester
https://amzn.to/2SXHad0
Launch Creader3001 Code Reader
https://amzn.to/2ROlIdk
