#lidlgliderconversion #lidlglider #StephenJonesRcAircraft
Converting a lidl chuck glider into a Rc Slope Flying Wing.
For a fast aerobatic Slope model.
The Sparr is 6x6x920mm spruce hot glued into a slot to support the wing.
I use cloth tape to cover the wing and give it extra strength starting from the rear of the wing. When one side was complete i slide the wing into the body and finished fitting the remaining Aileron and covered with tape .
When finished Hot glued into position.
Servos where fitted in the same way as my previous builds as was the radio gear.
Ailerons to be controlled using a delta mix on the radio.
Test flight to follow.
