**update 5/3/2016** It was confirmed, to get video voltage warnings to work, instead of using "3", set it to "30".. also, I was able to get RSSI output from the FrSky D4R-II receiver via its channel 2 (#2 pin) working. It might be necessary to change this entry from a 3 to a 2.
#define RCRSSI 2
In this video I go over the steps involved in wiring the hardware, as well as the flashing steps to get the software working and the OSD displaying properly.
Note: For a full outline of the steps involved in flashing, please see the article located here:
http://flight-stew.com/2016/04/27/v303x380-quad-adding-a-micro-minimosd-module-build-log/
- Hardware Overview and pre-wiring (Parts)
- Micro Minim OSD
- FTDI USB Updater
- Post Soldering (the Micro MinimOSD):
https://youtu.be/bA1eISFD7s4?t=321
- Schematic/Wiring Diagram:
https://youtu.be/bA1eISFD7s4?t=418
- Firmware Flashing Steps:
https://youtu.be/bA1eISFD7s4?t=667
- GUI Initial Configuration:
https://youtu.be/bA1eISFD7s4?t=1041
- First test of the OSD
https://youtu.be/bA1eISFD7s4?t=1300
- Micro MinimOSD final location on quad overview
https://youtu.be/bA1eISFD7s4?t=1363
- Another test of the OSD after more tweaks
- Update - flashing fixed and recap quick summary of steps to flash and code changes made
https://youtu.be/bA1eISFD7s4?t=1445
- Final test of the OSD in action (flashing GPS info fixed)
https://youtu.be/bA1eISFD7s4?t=1910
*Video voltage monitoring still needs to fire off an alarm at 3.0 volts, this still needs fixed, likely a code change somewhere
*There are good links for support on the GUI configuration located from within the GUI page itself**
Flight-Stew : http://flight-stew.com
Facebook: https://www.facebook.com/FlightStew
Google+: https://plus.google.com/u/0/b/116507970991605250384/116507970991605250384
Twitter: https://twitter.com/flightstew101