The Runcam Split works perfectly!
Its much lighter and better for Freestyle quads. I can highly recommend the Split!
Just make sure you have a Class 10 (minimum class6) SD card available.
I lost my card during a motor burnout this morning due to a faulty iPeaka 50A ESC.
Currently running a Class 4 SD card @ 1080p 20FPS, which is still not bad considering.
Also just a note, looks like having a lower class card in decreased your FPV cam feed and causes stuttering on the FPV side, the HD quality is still ok but FPV is bad… Oh well, we fly anyway
EDIT: Just realised I was flying on the wrong pid profile, thats why I was getting some serious propwash. Was flying on my profile setup for 3s, so pids were too high for the 4s here :/ whoops :)
Check out the artist's pages!
https://play.spotify.com/artist/67fzMHDSmWInaFqolzknKn?play=true&utm_source=open.spotify.com&utm_medium=open
https://www.facebook.com/ghostatlasofficial/
http://ghostatlas.bandcamp.com/
http://ghostatlas.storenvy.com/
Gear:
Radio: Spektrum DX6 gen2 Black edition w/ Serial Diversity RX (SPM4648)
Frame: iFlight iX5 4mm 3k CF 200mm
Motors: iFlight iF2207 2700kv / Silicon mounted.
Props: DALPROP Cylcone 5045c Tri blade
ESC's: DYS XS20a w/ Cap removed DSHOT600
FC: Matek F405 (supplied rubber soft mounts) w/ Betaflight 3.1.7 release / DSHOT600 / 32k-16k / BF-OSD
PDB: Matek FCHUB6s, mounted on a set of M3-6x6 Rubber soft mounts.
VTX: FT48X 5.8G 48CH 0.25/25/200/600mW- set @ 600mw
Antenna: Menace RC - Raptor Antenna - RHCP
Camera: Runcam Split / Gopro hero2 lens / 45+ Degrees up tilt
HD Camera: Runcam Split @ 1080p 30fps 20mbps (class 4 SD )
Battery: Tattu 4s 1300mah 95c
Weight: Around 480g
