Smartest 3D Print Upgrade Yet? | BIQU Panda Claw, Extruder & Jet on Bambu Lab P1S
#ad Thanks to BIQU for sending me these parts (https://biqu.equipment/collections/for-bambu-lab-printers)
Looking for the best upgrades for your Bambu Lab 3D printer? In this video, I install and test three exciting new mods from BIQU: the Panda Claw, Panda Jet, and Panda Extruder—all mounted on my Bambu Lab P1S.
While this video isn't sponsored, BIQU did provide the parts for free. As always, my opinions are honest and based on my own experience. In fact, not all parts I receive get featured in videos—but some are so good I use them on a daily basis, which says a lot about their quality. One upgrade I consistently use but haven't formally reviewed is the BIQU build plate. I especially love the CryoGrip surface—it’s worth checking out.
Whether you're looking to improve print quality, extrusion control, or bed adhesion, these upgrades are worth checking out.
???? Featured Products in This Video✅ BIQU Panda Claw✅ BIQU Panda Extruder✅ BIQU Panda Jet✅ BIQU Build Plate with CryoGrip
???? Watch till the end for my full review and thoughts on installation!
???? Links to all parts below
Links:
BQ Panda Extruder: https://tidd.ly/3ZVO6Mt
BQ Panda Claw: https://tidd.ly/3ZTQbIP
BQ Panda Jet: https://tidd.ly/44IYwSk
BQ Panda Jetpack: https://tidd.ly/3GgTIua
BQ building plate: https://tidd.ly/3I5I1XL
BQ cryogrip build plate: https://tidd.ly/4nu7cmO
Find me on Instagram:
https://www.instagram.com/lickyssmarthomechannel/
Support me:
Patreon: https://www.patreon.com/lickylauda
Paypal: https://paypal.me/lickylauda
Buy me a coffee: https://www.buymeacoffee.com/lickylauda
If you want to support me in any other way, please reach out to me by mail.
I am always looking to review new products !!
#BIQU #BigTreeTech #Panda #bambulab #bambulabp1p #bambulaba1 #bambulabx1c #pandaslovebambu #3DPrinting #BambuLabP1S #3DPrinterUpgrade #PandaClaw #PandaExtruder #PandaJet #CryoGrip #SmartHomePrinting
Chapters:
0:00 Intro
0:10 Unboxing
0:14 Panda Jet
0:48 Panda Extruder
1:12 Panda Claw
1:55 Disassembly
3:34 Replace the parts
3:38 Front cover
5:42 Extruder and Claw
9:43 Reinstall the extruder
11:17 Reconnect the cables
12:00 Patrons
12:08 Credits