I flew like **** in this heat because my quad wouldn't arm but that's not the point. ;)
HOW TO SET IT UP//
1. Install blheli_s 16.66 or higher.
2. Click "Show Unstable Releases" in the firmware flasher of BF
3. Install BF 3.2
4. In the modes tab enable "DSHOT Reverse Motors" on an AUX switch.
5. With props off! Engage the switch then arm. If it works then you're done. If not, double check everything.
MY SETUP:
QUAD:
Frame: Realacc X210
Motors: Emax RS2205 2300kv (thanks Chad ;)
ESCs: Racerstar 30a lites
Flight Controller: SP Racing F3
PDB: Matek PDB w/5v & 12v
VTX: Eachine TS5823S 200mw
Camera: Eachine 1000tvl
Antenna: Pagoda 2
Props: DAL 5040 v2 tris
Soft mounted FC & Motors
GEAR:
Transmitter: Flysky FS-i6
Goggles: Eachine EV800
LiPos: GNB 1300/1500mah 120c (Great for the price)
Charger: IMax B6 80w LiPro Charger + cheap balance board
GoPro Hero(4) Session: 1080p 60fps Protune
