I've been wanting to build this little guy ever since XHover announced it. Finally got around to doing it! I made a few modifications to allow me to better carry a Hero 7 which I talk about in the video. Mainly elongating the motor mounting holes from 9mm to 12mm to fit 4s capable motors (in this case 1407). This was my first micro build, so I did my best in picking the components. Hope you guys enjoy the video!
Micro Setup:
Frame - B-Roll (30mm standoffs) - https://bit.ly/2DSeopq
Motors - BrotherHobby 1407-4100kv
FC/4in1 - HobbyWing Nano Stack 20A (BF 3.5)
FPV Cam - Caddx Turtle V2
VTX - TBS Unify HV Race (200mw)
Antenna - VAS MinION RHCP
RX - CRSF Nano
Props - Azure Power 3060
GoPro Hero 7 (4k 60fps Wide Hypersmooth)
-Radio-
FrSky QX7
M7 Gimbals
Crossfire Micro
-Goggles-
Dominator V3s
Laforge V2
Mad Mushroom
VAS Crosshair
-Software-
Final Cut 10.4
After Effects
ReelSteady
Frames/Quad Parts
https://xhover.com
Batteries
http://www.thunderpowerrc.com
Quad Parts
https://www.droneracingparts.com
